Area Of Interest Starting Pixel - Basler L100k User Manual

Configuring the Camera

4.2.4.6 Area of Interest Starting Pixel

Purpose: To set the starting pixel for the Area of Interest or to read the current starting pixel setting.
See Section 3.8 for details.
Type: This is a read or write command.
Read Command:
Response:
Write Command:
Response:
Data Format:
Data Range:
4-16
DRAFT
Cmd-ID R/W-Flag
0xA9 1
Cmd-ID R/W-Flag
0xA9 0
Cmd-ID R/W-Flag
0xA9 0
None
Byte 1 Low byte of the starting pixel setting
Byte 2 High byte of the starting pixel setting
1K sensors: 0 (0x0000) to 1023 (0x03FF)
2K sensors: 0 (0x0000) to 2047 (0x07FF)
(When using binary commands, the starting pixel = n +1 where n is the
setting made using this binary command. For example, if you wish to define
pixel 100 as starting pixel, set 99 with the help of this command.)
Data Length Data
2
Data Length Data
2 2 Bytes
Data Length Data
2 2 Bytes
BASLER L100
-
k Series