Feed And Bobbin Module; Attachment Of Feed Adjuster Assy - Brother NV-10A Service Manual

Modules
1

Attachment of Feed adjuster assy.

1. Insert the polyester slider 2 and the spring
adjuster assy. 1.
*Key point
• Insert the spring starting with the side having the smaller
spring diameter.
2. Attach the feed adjuster assy. 1 to the base plate assy.
Lubricate the feed adjuster shaft with FBK OIL RO
100.
Apply EPNOC AP (N) 0 to the entire operating
part of the feed adjuster feed regulator slide block.
S10
1-1
Assembly of Feed adjuster assy.
1. Attach the F gear 2 to the feed adjuster 1.
*Key point
• When set it as shown in the right figure, check that the
protrusion 3 of the F gear 2 is the upper side.
2. Attach the spring S11
Apply EPNOC AP (N) 0 to the entire operating
surface of the feed adjuster and F gear.
S11
3 - 55

Feed and bobbin module

S10
9.9
8.8
5.5
.
15.1
5
into the shaft of the feed
1-2 drops
XC8388***
Small amount
XC8387***
SPRING
XC2531***
Small amount
XC8387***
SPRING
XC2530***
1
2
S10
1
1
S11
2
3