Needle-Presser Module And Feed Module Left-Right Position Alignment - Brother CS8000 Series Service Manual

Adjustment (Main Unit)
1. Attach the operation PCB assy. flat cable and power PCB assy. lead wire connector to the main PCB assy., and
attach the front cover to the arm bed.
2. Press and
3. <S2>
Select using
<S3>
Select using
base line position.
4. Turn the power off, disconnect lead wires A and B and remove the front cover.
5. Turn the pulley by hand, and insert the tip of the needle into the needle hole.
6. Loosen giza tites4X14 (two: feed module attachment) and giza tites 5X16 (two: lower shaft bearing presser
attachment).
7. Adjust the feed module left and right so that the tip of the needle and the needle hole V-groove come together.
8. Fully tighten the giza tites 4X14 (two: feed module attachment).
Giza tite 4X14
torque:
4 - 6

Needle-presser module and feed module left-right position alignment

while turning the power on (the buzzer will sound four times, and test mode will start).
, press once, and set the needle bar to the left base line position.
or , and after pressing
V groove
Needle
www.promelectroavtomat.ru
press
0.78 - 1.18 N-m
once, and set the needle bar to the left