Modules
4
Attachment of Rubber
1. Attach the rubber 1 to the shaft 2 of the base holder assy.
5
Attachment of Z zigzag cam
1. Attach the Z zigzag cam 1 to the shaft 2 of the base holder assy.
*Key point
• Check that the match mark 3 on the Z zigzag cam 1 Align
the match mark 5 on the Z pulse motor gear 4.
2. Attach the retaining ring E3 to the shaft 2 of the base holder assy.
Apply EPNOC AP (N) 0 to all of the sliding part of
the Z zigzag cam pin.
Apply EPNOC AP (N) 0 to all of the Z zigzag cam.
Apply EPNOC AP (N) 0 to the teeth around the Z
zigzag cam gear.
Needle-presser module
Bead
XC8387***
Bead
XC8387***
Bead
XC8387***
1
1
2
1
2
Retaining ring E3
3
5
4
3 - 44