Pc Programming Station (Pcps); Programmable Parameters - Otto Bock Skippi Service Manual

U Monitor
U Diagnostics
U Programming
U Favourites
U HHP settings
U File manager
U Plot & log
INFORMATION
For more information on the handheld programming device, please see the corresponding instruc-
tions for use (reference number 647G915).

8.3.2 PC programming station (PCPS)

The enAble40 control unit can also be programmed with the 1314 PCPS programming sta-
tion. In addition to the programming software, an interface is required to connect the com-
puter and control unit. An adapter is required to programme the enAble40 wheelchair control
unit. Article no. 493U32=SK185 includes the programming software, interface and adapter
cable.
INFORMATION
For more information on using the software, please see the enAble50 instructions for use (reference
number 647G490=D/GB). Note that only Section 5 of the document is used for an enable40 control
unit.

8.4 Programmable Parameters

WARNING
Risk of accidents and injury due to incorrect configuration settings. Modified parameter set-
tings in the configuration can lead to changes in driving characteristics. In particular, changes to the
speed, acceleration, braking or joystick settings can lead to unexpected and therefore uncontrolla-
ble operating performance with a risk of accidents.
Always test the driving characteristics of the power wheelchair after configuration / programming is
complete.
Programming must only be completed by authorised personnel. Neither Ottobock nor the control unit
manufacturer are liable for damages (especially in combination with special controls) caused by pro-
gramming that was not properly / professionally adapted to the abilities of the wheelchair user.
The enAble40 wheelchair control features a number of parameters that may be programmed
using the hand programming device or 1314 PC programmer. These programmable param-
eters allow the driving characteristics and performance of the vehicle to be adapted to special
deployment requirements. Information about the use of the hand programming device can be
found in Section 8.1.4.
Skippi
enAble40 wheelchair control – installation and programming
Ottobock | 49