Hand-Held Programming Device; Pc Programming Device; Programmable Parameters; Speed Settings - Otto Bock B400 Service Manual

VR 2 wheelchair control – Installation and programming

8.3.1 Hand-held programming device

InfoRmaTIon
Please read the PP1a programming device user manual before using such a device.
Should you wish to reprogram the control system make sure you consider all limitations described in
the user manual for the wheelchair.
Document all modifications for further reference.
The PP1a hand-held programming device enables access to programmable parameters for
adjusting the wheelchair to the individual requirements of the patient as well as to read error
reports and timer information (see section 8.4). It is connected to the control system via a con-
nector for making changes to the program settings.
Further information regarding use of the hand-held programming device can be found in the
"Programming and Diagnostics" user instructions for the PP1a hand-held programming device.

8.3.2 PC programming device

The PC programming device enables the same access as the PP1a hand-held programming
device. Further information regarding use of the software packages with the VR2 control can
be found in the documentation supplied with the software.

8.4 Programmable parameters

A selection of the programmable parameters available are given below. Information regarding
further programming can be found in the document "VR2 SERIES WHEELCHAIR CONTROL
SYSTEM; OPERATION, INSTALLATION & PROGRAMMING".

8.4.1 Speed settings

Parameter Setting range
Acceleration Steps of one
from 0 to 100
Deceleration Steps of one
from 0 to 100
Turn Acceleration Steps of one
from 0 to 100
Turn Deceleration Steps of one
from 0 to 100
74 | Ottobock
Description
Setting of forward and backward acceleration of the wheelchair.
A high value enables fast acceleration. This programmed ac-
celeration value appears when a speed setting of 5 has been
selected. Its value for other settings depends on the value of
the parameter "Minimum Acceleration".
Setting of the forward and backward deceleration (or brake)
of the wheelchair.
A high value enables rapid deceleration. This programmed de-
celeration value appears when a speed setting of 5 has been
selected. Its value for other settings depends on the value of
the parameter "Minimum Deceleration".
Setting of turn acceleration of the wheelchair.
A high value enables fast acceleration. This programmed ac-
celeration value appears when a speed setting of 5 has been
selected. Its value for other settings depends on the value of
the parameter "Minimum Turn Acceleration".
Setting of the turn deceleration (or brake) of the wheelchair.
A high value enables rapid deceleration. This programmed de-
celeration value appears when a speed setting of 5 has been
selected. Its value for other settings depends on the value of
the parameter "Minimum Turn Deceleration".
B400 Family