Table of Contents
Advertisement
WARNING
Insufficient ventilation of the battery charger while charging
Burns due to the battery charger overheating/catching fire
► Make sure the battery charger cannot overheat during the charging process.
► Ensure that the cooling fins/ventilation slots on the back of the device are not covered.
NOTICE
Improper charging
Damage to the battery due to user error
► Please note the manufacturer's instructions for the batteries being used. Follow the battery manufacturer
safety instructions.
► Avoid deep discharge of the battery. The manufacturer does not assume any liability for damage due to deep
discharge.
► Charge the battery immediately when the control panel indicates a deep discharge (see section "Buttons and
display functions").
INFORMATION
Charge the batteries of the power wheelchair for a longer time (over the course of 15 to 20 hours) once a week to
increase the battery service life.
12
7.10 Seat
7.10.1 Safety instructions
WARNING
Seat cushion and back support upholstery catching fire
Burns due to user error
► The seat cushion and back support upholstery as well as arm pads fulfil the normative requirements for flame
resistance. However, they may still ignite if fire is handled improperly or negligently.
► Keep away from all ignition sources, especially lit cigarettes.
490E163=*
Charging process via the control panel
1) Turn the control device on the power wheelchair off.
2) Connect the battery charger plug to the charging
receptacle on the power wheelchair control panel
(see fig. 12, item 1).
INFORMATION: Please note that charging via
the charging receptacle on the control panel
may only be carried out at a current of 5 A max.
3) Connect the battery charger to the mains network.
→ The charging process starts automatically and
the battery charge level is indicated by the bat
tery indicator on the control panel (see page 17)
and on the battery charger.
4) Disconnect the charging plug from the control pan
el after charging is complete.
INFORMATION: The power wheelchair cannot
be driven while the charging plug is connected.
5) Disconnect the charging plug of the battery charger
from the mains network after charging.
6) Turn the power wheelchair control device on. The
power wheelchair is ready to be used.
Use
27
Advertisement
Table of Contents
