Loading Your Software And Initial System Configuration; Loading The Cisco Telepresence System Administration Software - Cisco TelePresence System 1100 Assembly Manual

Loading your Software and Initial System Configuration

•
Register your system as a device in Unified CM. For more information, refer to the
Step 2
Cisco TelePresence Device"
Guide for the Cisco TelePresence
Add the TFTP server for your Unified CM server to your system using the Cisco TelePresence
Step 3
Administration Software GUI. For more formation, refer to the
Manager Settings"
For more information about configuring Unified CM with your Cisco TelePresence device, refer to the
Cisco Unified Communications Manager Configuration Guide for the Cisco TelePresence
Loading your Software and Initial System Configuration
This section provides the steps you use to load the Cisco TelePresence Administration onto your system
and includes the following sections:
•
•
•

Loading the Cisco TelePresence System Administration Software

the Cisco TelePresence System (CTS) Administration Software is factory-installed on each codec and
loads during initial bootup.
The CTS 1100 requires a minimum CTS Administration Software version of 1.5.11.
Note
To load CTS Administration Software:
Power on the PDU that is on the bottom of the cabinet by turning the switch to the On position.
Step 1
After you turn on the codecs, the displays associated with each codec becomes active. CTS displays
green check marks on all displays to show bootup progress. Bootup is complete when the system
displays six check marks as shown in
Cisco TelePresence System 1100 Assembly, First-Time Setup, and Field Replaceable Unit Guide
4-4
If you are upgrading from a software version that is 1.7.4 or later, follow the steps in the
the CTS Software for Systems That Are Running Cisco TelePresence Software Versions 1.7.4 and
Above" section.
section in the
of the Cisco TelePresence System Administration Guide
Loading the Cisco TelePresence System Administration Software, page 4-4
Configuring a Static IP Address for Networks That Do Not Use DHCP, page 4-9
Configuring an Alternate TFTP Server (Optional), page 4-11
Cisco Unified Communications Manager Configuration
System.
Figure 4-1.
Chapter 4 First-Time Setup
"Configuring a
"Cisco Unified Communications
for your software release.
"Upgrading
System.
OL-19695-01