Table of Contents
Advertisement
Chapter 3
Assembling and Mounting a Cisco TelePresence System 1100
Step 10
Determine the proper placement for the microphone for your table.
Figure 3-44
Note
Attach the microphone to the table by peeling the backing off the bottom of the microphone base and
Step 11
stick the microphone to the table.
Route the microphone cable from the table to the cabinet.
Step 12
Connect the DVI-to-VGA cable to the codec, using the "VGA input" connection on the codec as shown
Step 13
in
Figure
Place the Cisco Unified IP Phone on the table, and route the cable for the IP phone from the codec to the
Step 14
table. The connection for the Cisco Unified IP Phone is shown in
OL-19695-01
Microphone Placement Guidelines
A
44 inches
(112 cm)
minimum
18 inches
(46 cm)
30 inches (76 cm)
between participants
The CTS 1100 installation kit provides you with two microphones; you must install only one of
the microphones. Optionally, you can install the second microphone on the opposite side of the
table to provide full-table microphone coverage for audio-only conferences. If you install the
second microphone, install it 18 inches (46 cm) from the edge of the table that is closest to the
CTS 1100.
3-46; then, route the cable from the codec to the table.
Cisco TelePresence System 1100 Assembly, First-Time Setup, and Field Replaceable Unit Guide
Completing Installation and Cabling of the CTS 1100
A=B
B
8 feet (244 cm) recommended,
12 feet (366 cm) maximum)
Figure 3-46
as a phone icon.
3-55
Hide quick links:
Advertisement
Table of Contents
