Auto Collaboration Data Display - Cisco TelePresence System 1100 Assembly Manual

Auto Collaboration Data Display

Auto Collaboration Data Display
The Cisco TelePresence CTS 1100 ships with one unique output port that supports only one display of
data shared from other CTS endpoints. This port supports standard HDMI connectors and cables. If you
wish to connect more than one display for sharing data or presentations, it is necessary to purchase an
HDMI splitter and connect it to the Auxiliary control unit port.
Note
The supported output resolution is 1024x768 at 50/60 Hertz and is supported by all Cisco LCD displays.
Third-party displays which support these specifications may not be compatible. The HDMI to DVI cable
for the data display has to be purchased by the customer.
Cisco TelePresence System 1100 Assembly, First-Time Setup, and Field Replaceable Unit Guide
2-8
The high frame rate codec does not support 30 frames/sec in presentation-in-picture (PIP) mode.
An external display is recommended.
Chapter 2 Cisco TelePresence System 1100 Room Recommendations
OL-19695-01