Cisco TelePresence System 1100 Assembly Manual page 41

Chapter 3 Assembling and Mounting a Cisco TelePresence System 1100
b.
c.
Note
Step 2 Push the anchors into the holes that you drilled.
Figure 3-17 Inserting Anchors into the Drilled Holes
OL-19695-01
Using the 1/8-inch masonry drill bit, drill pilot holes to ensure that the holes are horizontally aligned
and level.
Drill into the pilot holes using the 10mm masonry drill bit.
Drill at least 75 millimeters into the concrete or brick wall.
Make sure that each mounting point can withstand a pull-out force of 32 pounds (14.5
kilograms).
14
15
Cisco TelePresence System 1100 Assembly, First-Time Setup, and Field Replaceable Unit Guide
Attaching the Mounting Bracket to a Concrete, Concrete Block, or Brick Wall
3-23