Chapter 4
First-Time Setup
If you need to obtain the IP address, complete the following steps:
Note
On the IP phone, locate Manual at the bottom of the screen and press the Manual soft key.
a.
Note
Locate Info at the bottom of the screen and press the Info soft key.
b.
Scroll down to the IP Address listing and copy the address.
c.
Log in to the system by entering the following information:
Step 7
Log in using the following:
Step 8
–
–
Attach the cabinet cover to the cabinet by completing the following steps:
Step 9
Set the lower part of the cabinet cover into the slotted groove in the lower part of the cabinet.
a.
Align the tabs in the upper part of the cabinet cover with the slots in the upper part of the cabinet.
b.
Rock the cover forward until the tabs go into the slots.
c.
Adjust the bar attached to the top of the light reflector by loosening the three screws and raising or
Tip
lowering the bar as required.
OL-19695-01
If you cannot locate the Manual button, proceed to Step
Username: admin (case sensitive)
Password: cisco (case sensitive)
Cisco TelePresence System 1100 Assembly, First-Time Setup, and Field Replaceable Unit Guide
Loading your Software and Initial System Configuration
b.
4-7