Cisco TelePresence System 1100 Assembly Manual page 83

Chapter 4 First-Time Setup
Parts List
Key Part Description
Camera Hood Assembly
1 Camera assembly
2
Camera front cover
3 Camera easel
4 Large camera target
5 Small camera target
6
Not used
7 Foam lens cover
8 Seat Alignment Guide
(Optional) Seat Alignment Guide Anchor
(Optional) Key for Seat Alignment Guide
Anchor
Configuring Cisco Unified Communications Manager for Your
Cisco TelePresence System
Before you can use your system, you need to configure your system in Cisco Unified Communications
Manager (Unified CM).
You can configure your system and complete all steps in this chapter prior to configuring your device in
Unified CM, but your device cannot place or receive calls until you complete the Unified CM
configuration. In addition, systems appear as either a Cisco TelePresence System 500-32 or a Cisco
TelePresence System 1000 in the Cisco TelePresence Administration GUI until you complete this
configuration.
To configure your device in Unified CM, complete the following steps:
Load the Cisco TelePresence Administration Software image on the Unified CM server.
Step 1
Note If your Unified CM is already running the required minimum software for your system, you can skip this
step. The Cisco TelePresence System 1100 requires a minimum version of CTS administration software
1.5.11 to run.
For more information, refer to the following sections in the
Guide:
•
OL-19695-01
Part Number
CTS1100-CAM-CLST
Part of CTS1100-CAM-CLST
Part of CTS-CAM-TOOL-G2
Part of CTS-CAM-TOOL-G2
Part of CTS-CAM-TOOL-G2
700-30077-01
800-32762-01
700-29875-01
700-29876-01
If you are upgrading from a software version that prior to 1.7.4, follow the steps in the
the CTS Software for Systems That Are Running Cisco TelePresence Software Versions Prior to
1.7.4" section.
Cisco TelePresence System 1100 Assembly, First-Time Setup, and Field Replaceable Unit Guide
Qty Ctn Notes
1 11
1 11
1 12
1 12
12
1 1
4 14
1 14
1 14
Cisco Telepresence Touch 12 Installation
Parts List
"Upgrading
4-3