Setting Parameters; Setting And Display Modes - Toshiba Tosvert VF-S15 Instruction Manual

4. Setting parameters

4.1

Setting and Display Modes

This inverter has the following three display modes.
Standard monitor mode
This mode is for monitoring the output frequency and setting the frequency reference value. If also
displays information about status alarms during running and trips.
・Display of output frequency, etc.
・Setting frequency reference values.
・Status alarm and trip
Setting monitor mode
The standard inverter mode. This mode is enabled when
inverter power goes on.
f710 Initial panel display selection
(f720 Initial extension panel display selection)
f702 Free unit display scale
If there is an error in the inverter, the alarm signal or the trip signal is displayed in the LED
display.
The mode for setting inverter parameters.
 How to set parameters, refer to section 4.2.
There are two parameter read modes. Refer to section 4.2 for details about
selection and switching of modes.
Easy setting mode
Standard setting mode : Both basic and extended all parameters are displayed.
● Each press of the EASY key switches between the Easy setting mode and the
Standard setting mode.
D-1
: Only the ten most frequently used parameters are
displayed.
Parameters can be registered as necessary.
(max. 32 parameters)
E6582175
4