Setting Parameters - Toshiba TOSVERT VF-nC3 Instruction Manual

When protection using a password is necessary, set and remove with the following method.
■ Password setup method
Preparation: Parameters other than  ,  , and  cannot be changed when  is set
to  or  .
(1)
(2)
(3)
(4)
Note: If you forget the password, it cannot be removed. Do not forget this password as we cannot retrieve it.
■Password examination method
(1)
(2)
(3)
6
(4)
(5)
(6)
When protecting a parameter is necessary with the external contact input terminal, set with the following
method.
■Prohibit changing parameter settings with contact input
Set "Parameter editing prohibited" for any input terminal.
Activating the "Parameter editing prohibited" function prevents changes to all parameters.
The following table shows an example of setting input terminal S2.

When  or  are read out and the value is  , a password is not set. A password can be
set.
When  or  are read out and the value is  , a password is already set.
If a password is not set, one can be set. Select and register a value between  and  for
 . The number becomes the password. It must be entered to remove the password, so do not
forget it.
The settings for parameter  cannot be changed.
When  or  are read out and the value is  , a password is set. Changing the
parameter requires removing the password.
Enter a the number (  to  ) registered to  when the password was set for  .
If the password matches,  blinks on the display and the password is removed.
If the password is incorrect,  blinks on the display and  is displayed again.
When the password is removed, the setting for parameter  can be changed.
By setting parameter  =  , the settings of all parameters can be changed.
Title Function
Input terminal selection 4A
(S2)
Adjustment range
200 (parameter editing prohibited)
0-201
201 (parameter editing prohibited reverse)
F-58
E6581595
Setting value