Toshiba Tosvert VF-S15 Instruction Manual page 163

[Setting of jog run mode (RES-CC)]
Ex) Assign jog run mode to control terminal RES.
Title
Input terminal selection (RES)
f113
Note 1: During the jog run mode, low speed detection signal (LOW) is output but designated frequency reach
signal (RCH) is not output, and PID control does not work.
Note 2: When only the operation panel is used for operation in jog run mode, the jog run function does not need to
be assigned to any input terminal.
<Examples of jog run>
RES (JOG): ON + F:ON: Forward jog run
RES(JOG): ON + R: ON: Reverse jog run
( Frequency command + F: ON: Forward run , Frequency command + R: ON: Reverse run )
Set frequency
ST-CC
F-CC
R-CC
RES-
(=18)
Frequency command input
 The jog run setting terminal (RES-CC) is enabled when the value of operation frequency is that of the jog
run frequency and below.
This connection does not function when operation frequency exceeds the jog run frequency.
 The motor can be operated in jog mode while the jog run setting terminals are connected (RES-CC).
 Jog run has priority to new operation command given during operation.
 Even for f261 = 0 or 1, an emergency DC braking (f603 = 2) is prior to the setting.
 No limits are imposed to the jog run frequency by the upper-limit frequency (parameter ul).
Function
0-203
Forward
Forward Forward
Reverse
0
F-51
Adjustment range
(Jog run mode)
E6582175
Setting
18
6