Table of Contents
Advertisement
6
Front operator panel buttons and LEDs
For more information about the front operator panel buttons and LEDs, see
page
32.
USB 3.2 Gen 1 (5 Gbps) connector
7
Connect a USB device, such as a mouse, keyboard, or other devices, to this connector.
8
Pull-out information tab
This tab contains below information:
• Network information such as MAC address and XCC network access label.
• Drive bay numbers.
For more information about this tab, see
page
47.
9
VGA connector
Connect a monitor to this connector.
Note: The maximum video resolution is 1920 x 1200 at 60 Hz.
Rear view
The following sections show the rear of the D3 Chassis and SD550 V3 node.
Chassis rear view
The following illustrations show the rear view of the ThinkSystem D3 Chassis.
Notes:
1. Depending on the specific configuration, the hardware might look slightly different from the illustrations
in this section.
2. The ThinkSystem D3 Chassis can contain up to four 1U nodes or up to two 2U nodes.
Important:
• For proper cooling, each node tray must be installed with either a node or node tray fillers before the
nodes in the chassis are powered on.
"Identify the system and access the Lenovo XClarity Controller" on
"Front operator panel LEDs" on
.
Chapter 2
Hardware components
23
Advertisement
Table of Contents
Troubleshooting
