Rear View - Lenovo ThinkEdge SE350 V2 User Manual

Rear view

The rear of the server provides access to several components, including the power supplies and Ethernet
port.
Rear view of ThinkEdge SE350 V2, DC power input
Figure 7. Rear view of ThinkEdge SE350 V2, DC power input
Table 6. Components on the rear view, DC power input
Threaded studs for grounding
1
RJ-45 RS-232 console connector
2
1 Power connectors
Connect DC power source or external power adapters to these connectors. Make sure the power cords are
connected properly. For more information, see
2 RJ-45 RS-232 serial console connector without LED
Connect a external RJ-45 serial COMM console cable to this connector.
3 Threaded studs for grounding
Connect the grounding wires to these lugs.
4 PMB status LED
For more information about this LED, see
Install I/O fillers
Install the I/O fillers when the connectors are not in use. The connectors could be damaged without proper
protection of the fillers.
PMB status LED
3
DC power inputs (two 6-pins 12V-48V power
4
connectors)
"Install a power adapter" on page
"PMB status LED" on page
64.
191.
.
Chapter 2 Server components
21