Table of Contents
Advertisement
Chapter 39: Multicast Filtering Commands
IGMP Filtering and Throttling
ip igmp filter
(Interface Configuration)
ip igmp max-groups
Console(config)#interface ethernet 1/1-28
Console(config-if)#ip igmp authentication
Console#
R
C
ELATED
OMMANDS
show ip igmp authentication
This command assigns an IGMP filtering profile to an interface on the
switch. Use the no form to remove a profile from an interface.
S
YNTAX
[no] ip igmp filter profile-number
profile-number - An IGMP filter profile number.
(Range: 1-4294967295)
D
S
EFAULT
ETTING
None
C
M
OMMAND
ODE
Interface Configuration
C
U
OMMAND
SAGE
The IGMP filtering profile must first be created with the
•
command before being able to assign it to an interface.
Only one profile can be assigned to an interface.
•
A profile can also be assigned to a trunk interface. When ports are
•
configured as trunk members, the trunk uses the filtering profile
assigned to the first port member in the trunk.
E
XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#ip igmp filter 19
Console(config-if)#
This command sets the IGMP throttling number for an interface on the
switch. Use the no form to restore the default setting.
S
YNTAX
ip igmp max-groups number
no ip igmp max-groups
number - The maximum number of multicast groups an interface
can join at the same time. (Range: 1-1023)
– 1179 –
ip igmp profile
Advertisement
Table of Contents
