Configuring Vlan Interfaces - Supermicro SSE-G2252 User Manual

Chapter 36: VLAN Commands

Configuring VLAN Interfaces

C VLAN I
ONFIGURING
operation. For more information on configuring RSPAN through
the CLI, see
D S
EFAULT ETTING
By default only VLAN 1 exists and is active.
C M
OMMAND ODE
VLAN Database Configuration
C U
OMMAND SAGE
• no vlan vlan-id deletes the VLAN.
no vlan vlan-id name removes the VLAN name.
•
no vlan vlan-id state returns the VLAN to the default state
•
(i.e., active).
You can configure up to 4094 VLANs on the switch.
•
E
XAMPLE
The following example adds a VLAN, using VLAN ID 105 and name RD5.
The VLAN is activated by default.
Console(config)#vlan database
Console(config-vlan)#vlan 105 name RD5 media ethernet
Console(config-vlan)#
R C
ELATED OMMANDS
show vlan (1093)
NTERFACES
Table 36-4: Commands for Configuring VLAN Interfaces
Command Function
interface vlan Enters interface configuration mode for a specified
VLAN
switchport acceptable- Configures frame types to be accepted by an interface IC
frame-types
switchport allowed vlan Configures the VLANs associated with an interface
switchport forbidden vlan Configures forbidden VLANs for an interface
switchport gvrp Enables GVRP for an interface
switchport Enables ingress filtering on an interface
ingress-filtering
switchport mode Configures VLAN membership mode for an interface
switchport native vlan Configures the PVID (native VLAN) of an interface
– 1086 –
"RSPAN Mirroring Commands" on page 976.
Mode
IC
IC
IC
IC
IC
IC
IC