Table of Contents
Advertisement
Chapter 39: Multicast Filtering Commands
MVR for IPv6
mvr6
source-port-mode
dynamic
mvr6
upstream-source-ip
E
XAMPLE
Console(config)#mvr6 robustness-value 5
Console(config)#
R
C
ELATED
OMMANDS
mvr6 proxy-switching (1230)
This command configures the switch to only forward multicast streams
which the source port has dynamcially joined. Use the no form to restore
the default setting.
S
YNTAX
[no] mvr6 source-port-mode dynamic
D
S
EFAULT
ETTING
Forwards all multicast streams which have been specified in a profile and
bound to a domain.
C
M
OMMAND
ODE
Global Configuration
C
U
OMMAND
SAGE
By default, the switch forwards any multicast streams within the
•
address range set by a profile, and bound to a domain. The multicast
streams are sent to all source ports on the switch and to all receiver
ports that have elected to receive data on that multicast address.
When the mvr6 source-port-mode dynamic command is used, the
•
switch only forwards multicast streams which the source port has
dynamically joined. In other words, both the receiver port and source
port must subscribe to a multicast group before a multicast stream is
forwarded to any attached client. Note that the requested streams are
still restricted to the address range which has been specified in a profile
and bound to a domain.
E
XAMPLE
Console(config)#mvr6 source-port-mode dynamic
Console(config)#
This command configures the source IPv6 address assigned to all MVR
control packets sent upstream on the specified domain. Use the no form to
restore the default setting.
S
YNTAX
mvr6 domain domain-id upstream-source-ip source-ip-address
no mvr6 domain domain-id upstream-source-ip
– 1232 –
Advertisement
Table of Contents
