Supermicro SSE-G2252 User Manual page 1040

Chapter 35: ERPS Commands
enable
guard-timer
enable command to stop the ERPS ring before making any
configuration changes to the control VLAN.
E
XAMPLE
Console(config)#vlan database
Console(config-vlan)#vlan 2 name rdc media ethernet state active
Console(config-vlan)#exit
Console(config)#interface ethernet 1/12
Console(config-if)#switchport allowed vlan add 2 tagged
Console(config-if)#interface ethernet 1/11
Console(config-if)#switchport allowed vlan add 2 tagged
Console(config-if)#exit
Console(config)#erps domain rd1
Console(config-erps)#control-vlan 2
Console(config-erps)#
This command activates the current ERPS ring. Use the no form to disable
the current ring.
S
YNTAX
[no] enable
D S
EFAULT ETTING
Disabled
C M
OMMAND ODE
ERPS Configuration
C U
OMMAND SAGE
Before enabling a ring, the east and west ring ports should be
•
configured on each node with the
specified with the rpl owner
with the control-vlan
• Once enabled, the RPL owner node and non-owner node state machines
will start, and the ring will enter idle state if no signal failures are
detected.
E
XAMPLE
Console(config-erps)#enable
Console(config-erps)#
R C
ELATED OMMANDS
erps (1051)
This command sets the guard timer to prevent ring nodes from receiving
outdated R-APS messages. Use the no form to restore the default setting.
– 1053 –
ring-port command, the RPL owner
command, and the control VLAN configured
command.