Supermicro SSE-G2252 User Manual page 1024

Chapter 34: Spanning Tree Commands
spanning-tree
loopback-detection
spanning-tree
loopback-detection
action
E
XAMPLE
Console(config)#interface ethernet 1/5
Console(config-if)#spanning-tree link-type point-to-point
This command enables the detection and response to Spanning Tree
loopback BPDU packets on the port. Use the no form to disable this
feature.
S
YNTAX
[no] spanning-tree loopback-detection
D S
EFAULT ETTING
Enabled
C M
OMMAND ODE
Interface Configuration (Ethernet, Port Channel)
C U
OMMAND SAGE
If Port Loopback Detection is not enabled and a port receives it's own
•
BPDU, then the port will drop the loopback BPDU according to IEEE
Standard 802.1W-2001 9.3.4 (Note 1).
Port Loopback Detection will not be active if Spanning Tree is disabled
•
on the switch.
E
XAMPLE
Console(config)#interface ethernet 1/5
Console(config-if)#spanning-tree loopback-detection
This command configures the response for loopback detection to block user
traffic or shut down the interface. Use the no form to restore the default.
S
YNTAX
spanning-tree loopback-detection action
{block | shutdown duration}
no spanning-tree loopback-detection action
block - Blocks user traffic.
shutdown - Shuts down the interface.
duration - The duration to shut down the interface.
(Range: 60-86400 seconds)
D S
EFAULT ETTING
block
– 1037 –