Table of Contents
Advertisement
Chapter 39: Multicast Filtering Commands
MVR for IPv4
mvr
robustness-value
Any membership reports received from receiver/source ports are
•
forwarded to all source ports.
When a source port receives a query message, it will be forwarded
•
to all downstream receiver ports.
When a receiver port receives a query message, it will be dropped.
•
E
XAMPLE
The following example enable MVR proxy switching.
Console(config)#mvr proxy-switching
Console(config)#
R
C
ELATED
OMMANDS
mvr robustness-value (1210)
This command configures the expected packet loss, and thereby the
number of times to generate report and group-specific queries. Use the no
form to restore the default setting.
S
YNTAX
mvr robustness-value value
no mvr robustness-value
value - The robustness used for all interfaces. (Range: 1-255)
D
S
EFAULT
ETTING
2
C
M
OMMAND
ODE
Global Configuration
C
U
OMMAND
SAGE
This command is used to set the number of times report messages are
•
sent upstream when changes are learned about downstream groups,
and the number of times group-specific queries are sent to downstream
receiver ports.
This command only takes effect when MVR proxy switching is enabled.
•
E
XAMPLE
Console(config)#mvr robustness-value 5
Console(config)#
R
C
ELATED
OMMANDS
mvr proxy-switching (1209)
– 1210 –
Advertisement
Table of Contents
