Table of Contents
Advertisement
Chapter 39: Multicast Filtering Commands
MVR for IPv6
mvr6 vlan group
E
XAMPLE
The following configures one source port and several receiver ports on the
switch.
Console(config)#interface ethernet 1/5
Console(config-if)#mvr6 domain 1 type source
Console(config-if)#exit
Console(config)#interface ethernet 1/6
Console(config-if)#mvr6 domain 1 type receiver
Console(config-if)#exit
Console(config)#interface ethernet 1/7
Console(config-if)#mvr6 domain 1 type receiver
Console(config-if)#
This command statically binds a multicast group to a port which will receive
long-term multicast streams associated with a stable set of hosts. Use the
no form to restore the default settings.
S
YNTAX
[no] mvr6 domain domain-id vlan vlan-id group ip-address
domain-id - An independent multicast domain. (Range: 1-5)
vlan-id - Receiver VLAN to which the specified multicast traffic is
flooded. (Range: 1-4094)
group - Defines a multicast service sent to the selected port.
ip-address - Statically configures an interface to receive multicast
traffic from the IPv6 address specified for an MVR multicast group.
This parameter must be a full IPv6 address including the network
prefix and host address bits.
D
S
EFAULT
ETTING
No receiver port is a member of any configured multicast group.
C
M
OMMAND
ODE
Interface Configuration (Ethernet, Port Channel)
C
U
OMMAND
SAGE
•
Multicast groups can be statically assigned to a receiver port using this
command. The assigned address must fall within the range set by the
mvr6 associated-profile
All IPv6 addresses must be according to RFC 2373 "IPv6 Addressing
•
Architecture," using 8 colon-separated 16-bit hexadecimal values. One
double colon may be used in the address to indicate the appropriate
number of zeros required to fill the undefined fields. (Note that the IP
address ff02::X is reserved.)
The MVR VLAN cannot be specified as the receiver VLAN for static
•
bindings.
– 1236 –
command.
Advertisement
Table of Contents
