Table of Contents
Advertisement
Chapter 39: Multicast Filtering Commands
MVR for IPv4
mvr proxy-
query-interval
S
YNTAX
mvr profile profile-name start-ip-address end-ip-address
profile-name - The name of a profile containing one or more MVR
group addresses. (Range: 1-21 characters)
start-ip-address - Starting IPv4 address for an MVR multicast
group. (Range: 224.0.1.0 - 239.255.255.255)
end-ip-address - Ending IPv4 address for an MVR multicast group.
(Range: 224.0.1.0 - 239.255.255.255)
D
S
EFAULT
ETTING
No profiles are defined
C
M
OMMAND
ODE
Global Configuration
C
U
OMMAND
SAGE
Use this command to statically configure all multicast group addresses
•
that will join the MVR VLAN. Any multicast data associated an MVR
group is sent from all source ports to all receiver ports that have
registered to receive data from that multicast group.
•
The IP address range from 224.0.0.0 to 239.255.255.255 is used for
multicast streams. MVR group addresses cannot fall within the reserved
IP multicast address range of 224.0.0.x.
IGMP snooping and MVR share a maximum number of 1023 groups.
•
Any multicast streams received in excess of this limitation will be
flooded to all ports in the associated domain.
E
XAMPLE
The following example maps a range of MVR group addresses to a profile:
Console(config)#mvr profile rd 228.1.23.1 228.1.23.10
Console(config)#
This command configures the interval at which the receiver port sends out
general queries. Use the no form to restore the default setting.
S
YNTAX
mvr proxy-query-interval interval
no mvr proxy-query-interval
interval - The interval at which the receiver port sends out general
queries. (Range: 2-31744 seconds)
D
S
EFAULT
ETTING
125 seconds
– 1208 –
Advertisement
Table of Contents
