Table of Contents
Advertisement
Chapter 38: Quality of Service Commands
rename
policy-map
This command redefines the name of a class map or policy map.
S
YNTAX
rename map-name
map-name - Name of the class map or policy map.
(Range: 1-32 characters)
C
M
OMMAND
ODE
Class Map Configuration
Policy Map Configuration
E
XAMPLE
Console(config)#class-map rd-class#1
Console(config-cmap)#rename rd-class#9
Console(config-cmap)#
This command creates a policy map that can be attached to multiple
interfaces, and enters Policy Map configuration mode. Use the no form to
delete a policy map.
S
YNTAX
[no] policy-map policy-map-name
policy-map-name - Name of the policy map.
(Range: 1-32 characters)
D
S
EFAULT
ETTING
None
C
M
OMMAND
ODE
Global Configuration
C
U
OMMAND
SAGE
Use the policy-map command to specify the name of the policy map,
•
and then use the
class
matches the criteria defined in a class map.
•
A policy map can contain multiple class statements that can be applied
to the same interface with the
Create a Class Map
•
E
XAMPLE
This example creates a policy called "rd-policy," uses the
specify the previously defined "rd-class," uses the set command to classify
the service that incoming packets will receive, and then uses the
flow
command to limit the average bandwidth to 100,000 Kbps, the burst
rate to 4000 bytes, and configure the response to drop any violating
packets.
– 1137 –
command to configure policies for traffic that
service-policy
(page
1137) before assigning it to a Policy Map.
command.
class
command to
police
Advertisement
Table of Contents
