Configuring Mac Based Vlans - Supermicro SSE-G2252 User Manual

Chapter 36: VLAN Commands

Configuring MAC Based VLANs

C MAC B
ONFIGURING
mac-vlan
--------------- ---------------
192.168.12.0 255.255.255.128
192.168.12.128 255.255.255.192
192.168.12.192 255.255.255.224
192.168.12.224 255.255.255.240
192.168.12.240 255.255.255.248
192.168.12.248 255.255.255.252
192.168.12.252 255.255.255.254
192.168.12.254 255.255.255.255
192.168.12.255 255.255.255.255
Console#
VLAN
ASED S
When using IEEE 802.1Q port-based VLAN classification, all untagged
frames received by a port are classified as belonging to the VLAN whose
VID (PVID) is associated with that port.
When MAC-based VLAN classification is enabled, the source address of
untagged ingress frames are checked against the MAC address-to-VLAN
mapping table. If an entry is found for that address, these frames are
assigned to the VLAN indicated in the entry. If no MAC address is matched,
the untagged frames are classified as belonging to the receiving port's
VLAN ID (PVID).
Table 36-11: MAC Based VLAN Commands
Command Function
mac-vlan Defines the IP Subnet VLANs
show mac-vlan Displays IP Subnet VLAN settings
This command configures MAC address-to-VLAN mapping. Use the no form
to remove an assignment.
S
YNTAX
mac-vlan mac-address mac-address [mask mask-address]
vlan vlan-id [priority priority]
no mac-vlan mac-address {mac-address | all}
mac-address – The source MAC address to be matched. Configured
MAC addresses can only be unicast addresses. The MAC address
must be specified in the format xx-xx-xx-xx-xx-xx or xxxxxxxxxxxx.
mask-address - Identifies a range of MAC addresses.
(Range: 00-00-00-00-00-00 to FF-FF-FF-FF-FF-FF)
vlan-id – VLAN to which the matching source MAC address traffic is
forwarded. (Range: 1-4094)
priority – The priority assigned to untagged ingress traffic.
(Range: 0-7, where 7 is the highest priority)
– 1112 –
------- --------
1 0
3 0
4 0
5 0
6 0
7 0
8 0
9 0
10 0
Mode
GC
PE