Table of Contents
Advertisement
Chapter 39: Multicast Filtering Commands
MVR for IPv6
mvr6 vlan
domain-id - An independent multicast domain. (Range: 1-5)
source-ip-address – The source IPv6 address assigned to all MVR
control packets sent upstream. This parameter must be a full IPv6
address including the network prefix and host address bits.
D
S
EFAULT
ETTING
All MVR reports sent upstream use a null source IP address
C
M
OMMAND
ODE
Global Configuration
C
U
OMMAND
SAGE
All IPv6 addresses must be according to RFC 2373 "IPv6 Addressing
Architecture," using 8 colon-separated 16-bit hexadecimal values. One
double colon may be used in the address to indicate the appropriate
number of zeros required to fill the undefined fields. (Note that the IP
address ff02::X is reserved.)
E
XAMPLE
Console(config)#mvr6 domain 1 upstream-source-ip 2001:DB8:2222:7223::72
Console(config)#
This command specifies the VLAN through which MVR multicast data is
received. Use the no form of this command to restore the default MVR
VLAN.
S
YNTAX
mvr6 domain domain-id vlan vlan-id
no mvr6 domain domain-id vlan
domain-id - An independent multicast domain. (Range: 1-5)
vlan-id - Specifies the VLAN through which MVR multicast data is
received. This is also the VLAN to which all source ports must be
assigned. (Range: 1-4094)
D
S
EFAULT
ETTING
VLAN 1
C
M
OMMAND
ODE
Global Configuration
C
U
OMMAND
SAGE
MVR source ports can be configured as members of the MVR VLAN using
the
switchport allowed vlan
command, but MVR receiver ports should not be statically configured as
members of this VLAN.
– 1233 –
command and
switchport native vlan
Advertisement
Table of Contents
