Table of Contents
Advertisement
Chapter 40: LLDP Commands
lldp tx-delay
lldp admin-status
E
XAMPLE
Console(config)#lldp reinit-delay 10
Console(config)#
This command configures a delay between the successive transmission of
advertisements initiated by a change in local LLDP MIB variables. Use the
no form to restore the default setting.
S
YNTAX
lldp
-delay seconds
tx
no lldp
-delay
tx
seconds - Specifies the transmit delay. (Range: 1 - 8192 seconds)
D
S
EFAULT
ETTING
2 seconds
C
M
OMMAND
ODE
Global Configuration
C
U
OMMAND
SAGE
•
The transmit delay is used to prevent a series of successive LLDP
transmissions during a short period of rapid changes in local LLDP MIB
objects, and to increase the probability that multiple, rather than single
changes, are reported in each transmission.
This attribute must comply with the following rule:
•
(4 * tx-delay)
refresh-interval
E
XAMPLE
Console(config)#lldp tx-delay 10
Console(config)#
This command enables LLDP transmit, receive, or transmit and receive
mode on the specified port. Use the no form to disable this feature.
S
YNTAX
lldp admin-status {rx-only | tx-only | tx-rx}
no lldp admin-status
rx-only - Only receive LLDP PDUs.
tx-only - Only transmit LLDP PDUs.
tx-rx - Both transmit and receive LLDP Protocol Data Units (PDUs).
D
S
EFAULT
ETTING
tx-rx
– 1250 –
Advertisement
Table of Contents
