Table of Contents
Advertisement
Chapter 39: Multicast Filtering Commands
MVR for IPv6
mvr6
proxy-switching
interval - The interval at which the receiver port sends out general
queries. (Range: 2-31744 seconds)
D
S
EFAULT
ETTING
125 seconds
C
M
OMMAND
ODE
Global Configuration
C
U
OMMAND
SAGE
This command sets the general query interval at which active receiver
ports send out general queries. This interval is only effective when proxy
switching is enabled with the
E
XAMPLE
This example sets the proxy query interval for MVR6.
Console(config)#mvr6 proxy-query-interval 1000
Console(config)#
This command enables MVR proxy switching, where the source port acts as
a host, and the receiver port acts as an MVR router with querier service
enabled. Use the no form to disable this function.
S
YNTAX
[no] mvr6 proxy-switching
D
S
EFAULT
ETTING
Enabled
C
M
OMMAND
ODE
Global Configuration
C
U
OMMAND
SAGE
When MVR proxy-switching is enabled, an MVR source port serves as
•
the upstream or host interface, and the MVR receiver port serves as the
querier. The source port performs only the host portion of MVR by
sending summarized membership reports, and automatically disables
MVR router functions.
•
Receiver ports are known as downstream or router interfaces. These
interfaces perform the standard MVR router functions by maintaining a
database of all MVR subscriptions on the downstream interface.
Receiver ports must therefore be configured on all downstream
interfaces which require MVR proxy service.
When the source port receives report and leave messages, it only
•
forwards them to other source ports.
When receiver ports receive any query messages, they are dropped.
•
– 1230 –
mvr6 proxy-switching
command.
Advertisement
Table of Contents
