Supermicro SSE-G2252 User Manual page 1213

Chapter 39: Multicast Filtering Commands
MVR for IPv6
MVR IP 6
FOR V
This section describes commands used to configure Multicast VLAN
Registration for IPv6 (MVR6). A single network-wide VLAN can be used to
transmit multicast traffic (such as television channels) across a service
provider's network. Any multicast traffic entering an MVR VLAN is sent to
all subscribers. This can significantly reduce to processing overhead
required to dynamically monitor and establish the distribution tree for a
normal multicast VLAN. Also note that MVR maintains the user isolation
and data security provided by VLAN segregation by passing only multicast
traffic into other VLANs to which the subscribers belong.
Table 39-20: Multicast VLAN Registration for IPv6 Commands
Command Function
mvr6 associated-profile Binds the MVR group addresses specified in a profile to
an MVR domain
mvr6 domain Enables MVR for a specific domain
mvr6 priority Assigns a priority to all multicast traffic in the MVR
VLAN
mvr6 profile Maps a range of MVR group addresses to a profile
mvr6 Configures the interval at which the receiver port sends
proxy-query-interval out general queries.
mvr6 proxy-switching Enables MVR proxy switching, where the source port acts
as a host, and the receiver port acts as an MVR router
with querier service enabled
mvr6 robustness-value Configures the expected packet loss, and thereby the
number of times to generate report and group-specific
queries
mvr6 source-port-mode Configures the switch to only forward multicast streams
dynamic which the source port has dynamcially joined
mvr6 upstream-source-ip Configures the source IP address assigned to all control
packets sent upstream
mvr6 vlan Specifies the VLAN through which MVR multicast data is
received
mvr6 immediate-leave Enables immediate leave capability
mvr6 type Configures an interface as an MVR receiver or source
port
mvr6 vlan group Statically binds a multicast group to a port
clear mvr6 groups Clears multicast group information dynamically learned
dynamic through MVR6
clear mvr6 statistics Clears the MVR statistics globally or on a per-interface
basis.
show mvr6 Shows information about MVR domain settings, including
MVR operational status, the multicast VLAN, the current
number of group addresses, and the upstream source IP
address
show mvr6 Shows the profiles bound the specified domain
associated-profile
show mvr6 interface Shows MVR settings for interfaces attached to the MVR
VLAN
– 1226 –
Mode
GC
GC
GC
GC
GC
GC
GC
GC
GC
GC
IC
IC
IC
PE
PE
PE
PE
PE