Drain Pan Switch - Henny Penny LVE-202 Technical Manual

7-20. DRAIN PAN SWITCH

Oct. 2010
Switch (P/N 85653) closes when drain pan is properly
positioned under fryer. If drain pan is not properly in place,
or drain switch is faulty, prompts such as,
"FILTER PAN MISSING"; "CHANGE FILTER PAD" show in
display.
To avoid electrical shock or property damage, move
power switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
1. Support control panel bottom with 1 hand, loosen
retaining screw at panel top, slide panel down slightly to
clear screw, push panel back up, then swing panel top out
and down.
2. Locate the 8-pin connector on the AIF PC board and
pull the connector from the board.
3. Check for proper continuity between the pins with wires
labeled D1 & D2. Switch can fail "open" or "closed". If
drain pan switch is defective, continue with replacement
instructions below.
Removal:
1. Drain pan switch is located under right frame rail on
which drain pan slides. Using a "stubby" 3/8" nut driver
or socket, remove 2 nuts securing switch to frame.
2. Using same tool, remove 3 nuts and wire clamps from
under frame rail.
3. Separate connector between the right and center doors
(below magnets) and push plug down through frame rail.
4. Mount new switch under rail and secure with 2 nuts.
Route wires through clamps, secure clamps to studs with
nuts, and push plug up through rail and connect.
5. Support control panel bottom with 1 hand, swing panel
top up about 90 degrees, slide panel down slightly to clear
screw, push panel top up to engage screw, then tighten
screw.
7-24
Model LVE-202, 203, 204
"CHECK PAN";