Electric Heating Element - Henny Penny LVE-202 Technical Manual

7-6. ELECTRIC HEATING
ELEMENT
Oct. 2010
The fryers are equipped with as few as 2 heating elements or as
many as 8 elements. If one of the small elements in the middle
needs replacement, 1 or 2 of the other elements must also be
removed to gain access to the faulty element.
See element specification chart on page 7-7.
Replacement
1. Drain oil from vat containing faulty element and any
adjoining split vats from which heaters must be removed to
gain access to defective element.
2. Using lift tool, raise the affected heating elements to assist in
replacement of the faulty element and support them using vat
lids or piece of lumber.
Avoid putting the lift tool in the same area as the high limit
bulb, or damage to the high limit could result.
To avoid electrical shock or property damage, move the
power switch to OFF and disconnect main circuit
breaker, or unplug cords at wall receptacle.
3. Using Phillip's-head screwdriver, remove 6 screws and
rear shroud.
4. Using a 1/2" wrench, remove 8 cap screws and 2 pivot
blocks holding faulty heater in place.
Carefully gather up any slack in the lead wires for the heaters in the
adjoining vats at the back of the fryer to minimize the amount of
disassembly of the pivot blocks and heaters to keep from discon-
necting all the wires but allow the defective heater to be replaced.
5. As needed, repeat previous step to remove any other pivot
blocks for adjoining split vats that help hold the faulty heater
in place.
7-5
Model LVE-202, 203, 204