7-6. ELECTRIC HEATING
ELEMENT(Continued)
7-7. BREAKERS
Dec. 2011
There are two breakers on the electric fryer which protect the filter
pump. To reset the breaker, open the left door and push up on the
plunger of the tripped breaker.
To avoid electrical shock or property damage, move the
power switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
1. Support control panel bottom with 1 hand, loosen retaining
screw at panel top, slide panel down slightly to clear screw,
push panel back up, then swing panel top out and down.
Checkout
2. Pull wires from breaker. Using a multimeter or continuity
light, check across terminals - circuit should be closed. If
not, replace the breaker.
Replacement
3. Open left door.
4. Using a 9/16" wrench, remove retaining nut from below and
remove breaker from controls area.
5. Install new breaker in reverse sequence.
6. Support control panel bottom with 1 hand, swing panel top
up about 90 degrees, slide panel down slightly to clear screw
head, push panel top up to engage screw, then tighten screw.
7-7
Model LVE-202, 203, 204