Henny Penny LVE-202 Technical Manual page 12

1-4. ERROR CODES (Continued)
DISPLAY
Programming failure
"E-41" ,
"E-46"
Analog converter chip or 12 volt
"E-47"
supply failure
Analog converter chip or 12 volt
"E-47"
supply failure
Input system error
"E-48"
Temperature input error
"E-54-C"
AIF PC board not communicating
with control PC board
"E-60"
Communication error
"E-62A"
"E-62B" Wrong calibration parameter
"E-62C" Shorted capacitance
"E-62D" Shorted RTD
"E-62E" Open RTD
"E-62F" Open capacitance
Out of range (TPM value over 35)
"E-62G"
Drain valve jumper wire missing or
"E-70-C" disconnected
"E-93-A" 24VDC tripped
May 2016
CAUSE
1-8
CORRECTION
Turn switch to OFF, then back to ON; if display
shows any of these error codes, re-initialize the
controls; if error code persists, check control
board and replace as needed
Turn switch to OFF, then back to ON; if "E-47"
persists, replace the PC board
Turn switch to OFF, then back to ON; if "E-47"
persists, replace the PC board
Turn switch to OFF, then back to ON; have
control PC board replaced if "E-48" persists
Turn switch to OFF, then back to ON;
have control PC board replaced if "E-54C"
persists
Turn switch to OFF, then back to ON; if "E-60"
persists, check 1.5 amp fuse on AIF PC board on
International units only; check connector between
the PC boards; replace AIF PC board or control
PC board if necessary
-Verify the OQM senser wiring is correct.
-Replace cable.
-Replace Sensor
Replace OQM Sensor
Replace OQM Sensor
Replace OQM Sensor
Replace OQM Sensor
Replace OQM Sensor
Replace oil and take a TPM reading, if the error
is still present replace OQM sensor.
Have the jumper wire checked on the PC board at
drain switch interlock position
Have drain actuator checked
Model LVE-202, 203, 204