Henny Penny LVE-202 Technical Manual page 44

7-6. ELECTRIC HEATING
ELEMENT
(Continued)
Oct. 2010
Replacement (continued)
6. Remove element sense switch arm from heater pin and
separate heater from pivot blocks.
7. Using 3/8" socket, remove nut and ground wire from stud.
8. Disconnect 3 heater wires from corresponding contactor in
controls area behind control panels. Pull 2 leads to rear of
fryer. Leave 1 lead in place to pull new leads through.
9. Disconnect 2 sensor wires from high temperature limit
control in panel beside JIB. Pull 1 lead to rear of fryer.
10. Record routing of lead wires through pivot blocks and fryer
sheet metal for use when installing new element.
11. Cut the 2 leads left in place and pull all remaining lead
wires through pivot block. Remove heating element.
12. Inspect and replace defective pivot block seals and
O-rings.
Reassembly
1. Position new element between pivot blocks and route lead
wires through blocks and sheet metal as recorded earlier.
2. Assemble heater elements, pivot blocks, and switch arms
making sure arms fully engage the pins on the elements and
that no wire leads are pinched or severely kinked.
3. Working from the center out, install all pivot blocks making
sure switch arms are located over switches and secure each
block with 4 screws. Tighten screws finger tight only.
4. Tape new thermocouple leads to old lead left in place, route
to panel beside JIB, and connect lead wires to high limit
control.
5. Tape new power leads to old lead left in place and route to
controls area at front of fryer and connect to contactor.
6. Align pivot blocks and heaters straight across front of
fryer and snug screws. Lower elements into vats and
adjust each so no element rubs side of vat. Make sure wires
are clear and element sense switches operate properly.
7. Torque each heater retaining bolt to 70 inch pounds.
8. Connect ground wires, install panel, restore power, and
test operation of fryer.
7-6
Model LVE-202, 203, 204