Problem
Filter motor runs but
pumps oil slowly
Filter motor will not run
"IS POT FILLED" filter error
prompt
"CHECK PAN" prompt
"CHANGE FILTER PAD"
prompt appears
Oct. 2010
Cause
FILTER MOTOR SECTION
• Filter line connections
loose
• Drain pan o-rings damaged
or missing
• Filter paper or pad clogged
• Power cord for vat #1
is not plugged-in
• Thermal reset button on
the rear of the pump motor
is tripped
DISPLAYED PROMPT SECTION
• All oil did not completely
return after a filter cycle
• Filter pad clogged
• Filter pan missing
• Filter pan not completely
engaged
• Filter pan interlock not
engaged
• Pad has not been changed
within a 24 hr period; Main
power switch was turned
off during filter pad change
• Drain pan microswitch
stuck
1-6
Model LVE-202, 203, 204
Correction
• Tighten filter line connections
• Install new o-rings
• Change filter paper or pad
• Plug power cord into
receptacle
• Allow time for the motor to
cool and then, using a screw-
driver, press hard against the
button until it clicks
• Have manager follow prompts
• Is JIB full? If not, fill JIB
• Replace filter pad/clean pan.
• Find pan and install
• Adjust filter pan
• Check microswitch
• Replace pad with NEW filter
pad with main power switch
on. *NOTE* 24/7 store :
Replace filter twice a day.
• Check microswitch