Oil Level Probes - Henny Penny LVE-202 Technical Manual

7-22. OIL LEVEL PROBES

Right Oil Left Oil
Level Probe Level Probe
Oct. 2010
The oil level probes monitor the oil level by temperature
differences. If they becomes disabled, the display shows:
"E-18A"= left probe; "E18-B"= right probe; "E18C"= both.
Note that left and right are as viewed from front of fryer.
Also, if any of the probes are out of calibration more than
10°F, or 10°C, the probe should be replaced. An Ohm check
can be performed also. See chart below left.
Checkout:
To avoid electrical shock or property damage, move the
power switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
1. Support control panel bottom with 1hand, loosen retaining
screw at panel top, let panel slide down slightly to clear
screw, push panel back up, then swing panel top out and down.
2. Pull probe connector on the left side, from control panel
and locate terminals in connector for probe being tested.
Attach meter leads onto those terminals and refer to chart at
left to determine if probe is good or not. (Probe wires are
labeled, with #1 being the far left probe.)
Replacement:
1. Reattach control panel and restore power to fryer.
2. Drain oil from vat.
3. Using Phillip's-head screwdriver, loosen retaining screw
from control panel top and swing down the control panel-.
4. Pull probe connector on left side of control panel.
5. Follow lead wires through insulation down to desired
probe.
6. Using a 1/2" wrench, remove nut on compression fitting
and remove oil level probe from vat.
7-26
Model LVE-202, 203, 204