7-21. FILTER AND JIB LIGHTS
Oct. 2010
Replacement
To avoid electrical shock or property damage, move the
power switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
1. Support control panel bottom with 1hand, loosen retaining
screw at panel top, let panel slide down slightly to clear
screw, push panel back up, then swing panel top out and
down.
2. Locate wires to light and cut wires.
3. Using a 13/16" deep-well socket (see photo at left), remove
nut on back side of panel and pull light from panel front.
4. Install new light with deep-well socket, connect wires with
wire nuts.
5. Support control panel bottom with 1 hand, swing panel top
up about 90 degrees, let panel slide down slightly to clear
screw head, push panel top up to engage screw, then tighten
screw.
6. Restore power to the unit.
7-25
Model LVE-202, 203, 204