7-14. FILTER PUMP &
MOTOR (Continued)
Oct. 2010
7. Using 7/16 in. wrenches, remove 3 nuts, lockwashers, flat
washers, spacer washer sets, and bolts securing the motor
to the motor bracket.
8. Pull the pump and motor assembly from fryer.
9. Re-install pump and motor assembly following the above
steps in reverse order; however, leave assembly mounting
bolts and nuts loose and perform position adjustment after
all electrical and plumbing connections are made.
To replace pump on motor:
1. Using a 1/2 in. wrench, remove 2 bolts securing the pump
to the motor and pull the pump from the motor.
2. Install a new seal kit (part no. 17476) onto shaft of motor.
3. Align the motor shaft motor with the pump rotor on the
inside of pump body and push pump on motor shaft.
4. Secure the pump to the motor with the 2 bolts.
To adjust pump and motor assembly position:
1. Loosen bolts and nuts securing assembly to bracket.
2. Slide filter pan in under fryer on the rails until it rests
against drain trough nozzle so drain pan cover opening is
aligned with nozzle.
3. Check to be sure drain pan latch fully engages pan with
about 1/16" (2 - 3 mm) of play. Adjust as needed.
4. Move pump and motor assembly so both O rings on drain
pan fully engage Plug and Play connector and no O ring is
visible.
5. Tighten bolts and nuts securing assembly to bracket.
7-20
Model LVE-202, 203, 204