Control Panel And Menu Card Replacement - Henny Penny LVE-202 Technical Manual

7-4. CONTROL PANEL &
MENU CARD
REPLACEMENT
Oct. 2010
Should the control panel become inoperative, or the menu card
needs changed, follow these instructions:
Control Panel Replacement
1. Remove electrical power supplied to the vat.
To avoid electrical shock or property damage, move the
power switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
2. Support control panel with one hand, loosen retaining screw
at panel top, slide panel down enough to clear screw, push
panel back up, then swing panel top out and down.
3. Unplug connectors on back of control panel.
4. Support control panel bottom with one hand, swing panel
top up about 90 degrees, let panel slide down until hinge
tabs come out of shroud slots, and remove panel.
5. Install new control panel by inserting hinge tabs in slots.
6. Plug connectors into back of control panel per label on
panel or refer to diagram on page 7-29.
7. Support control panel bottom, swing panel panel top up
about 90 degrees, slide panel down slightly to clear screw
head, push panel top up to engage screw, then tighten screw.
8. Connect power and check operation of unit
Menu Card Replacement
1. Perform steps 1 and 2 above.
2. Loosen tape securing card at right side of control panel and
pull card from panel. Carefully slide new menu card back
into panel slot and secure with tape.
3. Perform steps 7 and 8 above.
7-2
Model LVE-202, 203, 204