Henny Penny LVE-202 Technical Manual page 35

5-5. TECH MODE (Continued)
Oct. 2010
T-20 - PUMPS & VALVES (Continued)
Press to open and close the RTI discard valve (display shows
"DISCARDo" when open)
Press to open and close the RTI JIB fill valve (display shows
"JIBFILLo" when open)
Press and "SEL-VALV" "AT HOME" shows in the dis-
plays.
Press button and "REV, CNT" " HOM, POS" followed by
actual data values such as "3.19R 10P" "14.4° 15.2°". One
revolution of the valve took 3.19 seconds, counted 10 ports
during the revolution, the dwell angle of the home switch was
14.4°, and the dwell angle of the position switch was 15.2°.
Press button and "CALIBRAT" "AT HOME" show in the
displays. Press √ button to request a calibration, data values as
above will appear in the displays.
Press button and "NEXT POS" "AT HOME" show in the
displays. Press left √ button and valve moves to next port position.
Press button and "CONT RUN" "AT HOME" show in the
displays. Press left √ button and valve will run continuously until
you press the STOP button.
Press button and "RAW√ MTR_" "D√ Hx P*" shows in the
displays. The √ indicates a signal was constanly "ON", the "_"
means a signal was constantly "OFF", and the "X means the signal
was both "ON" and "OFF".
Press button and "PUMP FP_" and "JP_ NP_" shows in the
displays. (Driven by the AIF board)
Press to turn off and on the filter pump (display shows "FP*"
when on)
Press to turn off and on the JIB pump (display shows "JP*"
when on)
Press to turn off and on the RTI new oil pump (display
shows "NP*" when on)
Press button and "LIGHTS" and "FLT_ JLO_" shows in
the displays. (Driven by the AIF board)
5-11
Model LVE-202, 203, 204