Manual Operation Of Drain Valve - Henny Penny LVE-202 Technical Manual

7-23. MANUAL OPERATION
OF DRAIN VALVE
Set Screws
Oct. 2010
Should the actuation motor of a drain valve cease to operate,
the drain valve can be operated manually as follows.
To avoid electrical shock or property damage, move the
power switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
1. Support control panel bottom with 1hand, loosen retaining
screw at panel top, let panel slide down slightly to clear
screw, push panel back up, then swing panel top out and down.
2. Trace wires from P12 on panel to vertical wall of controls
area and separate required connector.
3. Using a 7/32" Allen wrench, loosen and unscrew 2 set
screws until almost removed.
4. Using a flat blade screwdriver, pry motor from valve body.
5. Using a 1/4" or adjustable wrench, turn square stub shaft
to operate valve ball.
6. Assemble in reverse order.
7. Support control panel bottom with 1 hand, swing panel top
up about 90 degrees, let panel slide down slightly to clear
screw head, push panel top up to engage screw, then tighten
screw.
7-28
Model LVE-202, 203, 204