7-19. DRAIN PAN SWITCH
Feb. 2011
This switch closes when the drain pan is pushed properly in
place under the fryer. If the drain pan is not properly in place,
or the drain switch is faulty, display prompts such as,
PAN"; "CHANGE FILTER PAD" shows in the display.
To avoid electrical shock or property damage, move
the power switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
1. Remove control panel and hinge it down.
2. Locate the 8-pin connector on the AIF PC board and
pull the connector from the board.
3. Check for normally open circuit between pins with wires
labeled D1 & D2. If the circuit shows closed, continue
with the replacement instructions below.
Removal:
1. Drain pan switch is located on the rear of fryer. Using a
3/8" socket or nut driver, remove the nuts securing the
drain switch bracket to the fryer.
2. Using a 1/8" Allen wrench, remove shoulder bolt securing
the cover and remove cover.
3. Using a Phillips-Head screwdriver, remove screws
securing switch to bracket and remove switch.
4. Label and remove wires from switch.
Normally
Closed
Normally
Open
7-22
Model LVE-102, 103, 104
"CHECK
Common