Section 2. Info, Filter & Temp Button Stats; Info Button Stats; Filter Button Stats; Temp Button Stats - Henny Penny LVE-202 Technical Manual

SECTION 2. INFO, FILTER & TEMP BUTTON STATS

2-1. INFO BUTTON STATS

2-2. FILTER BUTTON STATS

2-3. TEMP BUTTON STATS

May 2016
Recovery Information for each Vat/OQM Information
1. Press and release
the recovery time that oil temperature went from 250°F
(121°C) to 300°F (149°C) shows in the right display. For
example, REC
30 seconds for the oil temperature to recover to 300°F
(149°C) from 250°F (121°C).
1a. Press and release
reading, date of the last TPM reading, and time stamp of
last TPM reading (only if OQM sensor is installed and
enabled).
2. Pressing the button twice shows 1st language in left
display and, if programmed, 2nd language in right display.
If no buttons are pressed within 5 seconds in any of stats
modes, the controls revert back to normal operation.
Cook Cycles Remaining before Filtering
1. Press and release either
shows "COOKS REMAIN" and right display shows the
number of cook cycles before the next auto filter. For
example,
REMA IN
means after 3 more cook cycles on the left vat, the controls
ask operator if they are ready to filter or not. But, 6 more
cook cycles remain on the right vat.
Time and Date
2. Press either or
shows in the displays.
Filter Pad Usage
3. Press either or
the present filter pad has been used is shown in displays.
2-1
Model LVE-202, 203, 204
and REC shows in left display and
5:30 means it took 5 minutes and
, the display will show the last TPM
or and the left display
3 6
twice and time-of-day and date
three times and number of hours