Drain Valves - Henny Penny LVE-202 Technical Manual

7-13. DRAIN VALVES

Set Screws
Oct. 2010
Replacement
Each vat drain valve is opened and closed by an actuator. If oil
won't drain or pump back into a vat, the actuator may be faulty.
To avoid electrical shock or property damage, move
power switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
1. Support control panel bottom with 1hand, loosen retaining
screw at top, slide panel down slightly to clear screw, push
panel bottom up, then swing panel top out and down.
2. Trace wires from P12 on panel to vertical wall of controls
area and separate required connector.
3. From the rear of the fryer and using a 3/8" wrench,
remove 2 nuts securing seal clamp to drain trough studs.
4. Grasp drain valve and motor assembly, turn assembly 1/8
turn (45 degrees) counter clockwise (CCW) and slide
assembly down so valve inlet clears vat drain tube.
5. Lift clamp up off of drain trough studs and maneuver
valve and motor assembly with lower drain tube attached
from under the fryer.
6. Remove shims, O-ring and clamp from lower drain tube.
7. Using large slip joint pliers, turn lower drain tube 1/8 turn
(45 degrees) CCW and remove tube from valve.
8. Remove O-rings from inlet and outlet sides of valve body.
9. Using a 7/32" Allen wrench, loosen and unscrew 2 set
screws until almost removed.
10. Using a flat blade screwdriver, pry motor from valve body.
11. Re-assemble in reverse order. Lubricate all O-rings with
cooking oil. Align "nubs" on drain tubes with notches in
valve body, push the tube into valve body and turn 1/8 turn
(45 degrees) clock wise (CW) to lock position.
7-17
Model LVE-202, 203, 204