Table of Contents
Advertisement
4.1.2.1 PROGRAMMING A CAPTURE
To program the capture of an Inrush current, proceed as follows:
1. At the Waveform Capture screen, select Inrush Current. The Capture Schedule screen is displayed.
Item Function
1
Reminder of the mode used
2
Display of sub-mode used
3
Current date and time
4
Battery charge level
Rapid programming and starting of a capture. When this button is pressed, the recording starts immediately with a current threshold of
5
0A and a hysteresis of 100%
6
Displays Configuration screen to set triggering thresholds
7
Displays the parameters of the capture
8
Programs the capture
: confirms programming of a capture
9
: deletes a capture (this icon is displayed if a capture has been made)
2. To program a capture, enter the triggering filter (3A, A1, A2, or A3), the start date and time, and the recording mode
(RMS + PEAK or RMS only).
The RMS + PEAK recording mode is used to produce a trend recording of the half-period RMS values and a trend
recording of the samples (envelopes and waveforms). The maximum duration of such a recording depends on the
frequency and is on average about one minute.
In the RMS only recording mode, the recording of the samples is eliminated in favour of a longer maximum capture
duration. This mode records only the half-period RMS values and its maximum duration is about ten minutes.
3. To modify an item, move the yellow cursor to it using the ▲ and ▼ buttons, then validate with the
the value using the ◄ ►▲▼ buttons, then validate again.
NOTE: The triggering filter appears in red if it is not available because of an incompatibility with the configuration
(connection, type of sensors, or current ratio).
Power Quality Analyzer PowerPad
Find Quality Products Online at:
®
III Model 8435
GlobalTestSupply
www.
Figure 4-6
.com
button. Change
sales@GlobalTestSupply.com
39
Advertisement
Table of Contents
