Table of Contents
Advertisement
4.4.5 DELETING AN ALARM LOG
1. Press the
icon's yellow button.
2. Select the alarm to be deleted using the ▲ or ▼ button, then press the
To leave this screen without deleting any alarm, press the
4.5 TREND MODE
4.5.1 PROGRAMMING AND STARTING A RECORDING
NOTE: The ON/OFF light will blink when the recording is in progress. When the recording is done, the ON/OFF light will turn off.
You will need to press it again to restart the instrument.
This mode enables all the parameters previously configured in the Configuration mode
1. Press the Trend mode button -
2. Select the Configuration that was previously set-up (see § 3.2.7) by using the ▲ or ▼ button to highlight Set-up, then
press the
button.
3. Use the ▲ or ▼ button to choose Configuration 1, 2, 3, or 4, then press
4. Select the Start field using the ▼ button. Press
buttons to change the date and time. Press
5. Using the same method as steps 1, 2, and 3, use the arrow buttons and the
Period, and Name.
6. Press the
icon's yellow button to begin recording between your specified start and end times. The
disappears and the icon
7. The Recording on Standby message is displayed and the icon blinks on the top display bar. Once the start time has
been reached, the Recording running message is displayed.
8. When the recording is finished, the Programming a recording screen will appear and the
Power Quality Analyzer PowerPad
Find Quality Products Online at:
.
when finished.
appears.
®
III Model 8435
GlobalTestSupply
www.
button to confirm deletion.
button.
Figure 4-37
.
to select the date and time field, then use the appropriate arrow
.com
to be recorded (see § 3.2).
button to change the values for Stop,
icon
icon reappears.
sales@GlobalTestSupply.com
63
Advertisement
Table of Contents
