Table of Contents
Advertisement
Item Function
Selection of display filters
- 4V: displays the 4 single voltages during the transient (here in a 5-wire tri-phase connection)
1
- 4A: displays the 3 phase currents and the neutral current during the transient
- L1, L2 or L3: displays the current and the single voltage successively in relation to phases 1, 2 and 3
- N: displays neutral
2
Instantaneous value of the signals according to the position of the cursor on the scale. To move the cursor use the ◄ and ► buttons.
: Zoom Out - To zoom out press the yellow button for this icon.
3
: Zoom In - To zoom in press the yellow keypad button for the icon.
5. To return to the Transient List screen, press
4.1.1.4 DELETING A TRANSIENT
1. From the Detection List screen, select the transient to be deleted using the ▲ and ▼ buttons, then press
2. Press the
icon's yellow button to delete the selected transient.
3. To leave this screen without deleting, press any of the Mode buttons on the Model 8435.
To return to the Waveform Capture screen, press
4.1.2 INRUSH CURRENT MODE
The
mode is used to capture (record) Inrush currents and to view and delete the recordings. Only a single Inrush
current capture is kept in memory.
NOTE: When Inrush Current mode is selected the display screen will depend on the following conditions:
if ...
no capture has been made
captures have been made
38
Find Quality Products Online at:
Figure 4-5
.
.
then ...
the Capture Schedule screen is displayed
the Capture Parameters screen is displayed
GlobalTestSupply
www.
Power Quality Analyzer PowerPad
.com
sales@GlobalTestSupply.com
.
®
III Model 8435
Advertisement
Table of Contents
